新闻动态
新闻动态 当前位置:首页>新闻动态>新闻动态

首先拆下制砂机电机的外部接线并进行标记

网址:www.ccdrc.cn  2019-08-01  作者:admin    阅读:

首先,打开制砂机的端盖,将拆下的端盖的螺丝拧入专门设置在制砂机设备电机端盖上的两个螺孔中,使盖子更重,并应用起重设备端盖并逐渐将其取下。
Firstly, open the end cap of the sand machine, and screw the screw of the removed end cap into two holes specially arranged on the motor end cap of the sand machine equipment to make the cap heavier, and apply the end cap of the lifting equipment and gradually remove it.
接下来,首先拆下制砂机电机的外部接线并进行标记。例如,对于异步电动机,应该制作对应于三相电力线的标记,并且并联绕组,电枢绕组等应该分别对应于外部布线。标记。然后松开脚螺钉,将电机与驱动机构分开。然后使用机器设备电机轴上的皮带轮或联轴器。有时需要在滑轮的电机轴之间的间隙中添加一些煤油,以使煤油渗透并润滑,使其与车轮紧密接合,并且需要将车轮快速加热(同时缠绕轴)用湿布)去除轮子。
Next, first remove the external wiring of the sand machine motor and mark it. For example, for asynchronous motors, markers corresponding to three-phase power lines should be made, and parallel windings and armature windings should correspond to external wiring respectively. Marking. Then loosen the foot screw and separate the motor from the driving mechanism. Then use the pulley or coupling on the motor shaft of the machine equipment. Sometimes kerosene is added to the clearance between the motor axles of the pulley to make kerosene permeate and lubricate, so that it is closely connected with the wheel, and the wheel needs to be quickly heated (while winding the axle) with wet cloth to remove the wheel.

转让电话
13313028229